机械磨具外文翻译资料（doc 7页）

机械磨具外文翻译资料内容提要：
General all-steel punching die’s punching accuracy
General all-steel punching die’s punching accuracy
Accuracy of panel punching part is display the press accuracy of the die exactly. But the accuracy of any punching parts’ linear dimension and positional accuracy almost depend on the blanking and blanking accuracy,. So that the compound mould of compound punching’s accuracy, is typicalness and representation in the majority.
Analyse of the die’s accuracy
For the analyse of pracyicable inaccuracy during production of dies to inactivation, we could get the tendency when it is augmentation in most time. From this we could analyse the elements. When the new punch dies pt into production to the first cutter grinding, the inaccuracy produced called initial error; if the die grinding more than twenty times, until it’s discard, the inaccuracy called conventional error; and before the dies discard, the largest error of the last batch permit, called limiting error. at job site, the evidence to confirm life of sharpening is the higher of the blanking, punched hole or punched parts. Because all finished parts had been blanked ,so it is especially for the compound dies. Therefore, the analyse of burr and measurement is especially important when do them as enterprise standardization or checked with <<the height of punching part>>.
The initial error usually is the minimal through the whole life of die. Its magnitude depend on the accuracy of manufacture, quality, measure of the punching part, thickness of panel, magnitude of gap and degree of homogeneity. The accuracy of manufacture depend on the manufacture process. For the 1 mm thicked compound punching part made in medium steel, the experimental result and productive practice all prove that the burr of dies which produced by spark cutting are higher 25%~~30% than produced by grinder ,NC or CNC. The reason is that not only the latter have more exact machining accuracy but also the value of roughness Ra is less one order than the formmer, it can be reached 0.025μm. Therefore, the die’s initial blanked accuracy depends on the accuracy of manufacture, quality and so on.

..............................

上一篇：各类机床夹具介绍（ppt 63页）

下一篇：机械安全设计的主要内容与基本原则（ppt 

石墨电极镗孔专机机械系统设计论文(doc 42页)

食品粉碎切割机械介绍(ppt 83页)

机械装配图绘制讲义(ppt 34页)

机械安全控制系统介绍(pdf 36页)

国家标准机械制图的部分规定(ppt 55页)

现代机械设计概论(ppt 41页)