机械类英文翻译资料（doc 10页）
所属分类：机械行业
文件大小：228 KB
下载要求：10 学币或VIP
点击下载
资料简介：
机械类英文翻译资料内容提要：
From Peter Smid, CNC Programming Handbook: A Comprehensive Guide to Practical CNC Programming, Second Edition, Industrial Press, Inc. 200 Madison Avenue, New York, 2003.
CHAPTER 6: PROGRAMMING PLANNING
The development of any CNC program begins with a very carefully planned process. Such a process starts with the engineering drawing of the required part. Before the part is machined, several steps have to considered and carefully evaluated. The more effort is put into the planning stage of the program, the better results may be expected at the end.
STEPS IN PROGRAM PLANNING
The steps required in program planning are decided by the nature of the work. There is no formula for all the jobs, but some basic steps should be considered:
Initial information / Machine tools features
Part complexity
Manual programming / computerized programming
Typical programming procedure
Part drawing / Engineering data
Methods sheet / Materials specifications
Machining sequence
Tooling selection
Part setup
Technological decisions
Work sketch and calculations
Quality considerations in CNC programming
The steps in the list are suggestions only a guideline. They are quite flexible and should always be adapted for each job and to the specific conditions of the work.
INITIAL INFORMATION
Most drawings define only the shape and size of the completed part and normally do not specify data about the initial blank material. For programming, a good knowledge of the material is an essential start - mainly in terms of its size, type, shape, condition, hardness, etc. The drawing and material data are the primary information about the part. At this point, CNC program can be planned. The objective of such a plan is to use the initial information and establish the most efficient method of machining, with all related consideration – mainly part accuracy, productivity, safety and convenience.
The initial part information is not limited to the drawing and the material data, it also includes conditions not covered in the drawing, such as pro- and post- machining, grinding allowances, assembly features, requirements for hardening, next machine setup, and others. Collecting all this information provides enough material to start planning the CNC program.
..............................
精品资料网 m.cnshu.cn
Copyright © 2004- 粤ICP备10098620号-1
